COMPAQ DX2810 DRIVER DOWNLOAD

Type 1 Battery Holder. Remove the two screws that secure the drive to the drive cage 1 , then slide the drive out of the front of the chassis 2. Also, if you are replacing the primary hard drive, make sure you have created a Recovery Disc Set to restore the operating system, software drivers, and any software applications that were preinstalled on the computer. Remove the optical drive Removing an Optical Drive. Reconnect the power cord and any external devices, then turn on the computer. Cable Connections System board connectors are color-coded to make it easier to find the proper connection.

Uploader: Akitilar
Date Added: 3 November 2008
File Size: 9.12 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30972
Price: Free* [*Free Regsitration Required]

Push the other edge down until the clamp snaps over the other edge of the battery.

HP COMPAQ DX User Manual | 29 pages

Certain restrictions and exclusions apply. Got it, continue to print.

XMM1 socket, Channel A populate first. Press outward on the three latches on the right side of the bezel 1then rotate the right side of the bezel off the chassis 2 followed by the left side. Type 3 Battery Holder. Comments and Feedbacks All comments and feedbacks to http: If one channel will have more memory than the other, the larger amount should be assigned to Channel A.

  ASUS P5B-VM SE LAN DRIVER

HP Compaq dx Microtower PC – Driver Downloads | HP® Customer Support

Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. Disconnect the heatsink control cable from the system board and remove the heatsink Heatsink assembly. Don’t show me this message again. Loosen the captive thumbscrew 1 that secures the access panel to the computer chassis.

System Fan Prepare the computer for disassembly Preparation for Disassembly. Intel Core 2 Quad Processors: If the alarm sounds, unplug the computer and leave it unplugged until the access panel is replaced. You must disconnect the power cord and wait approximately 30 seconds for the power to drain before adding or removing memory modules.

Intel Core 2 Duo E Processor 3. Asia Pacific and Oceania.

HP Compaq dx2810 Quickspecs

For dual-channel symmetric performance, the total amount xompaq memory in each channel must be equal. Batteries, battery packs, and accumulators should not be disposed of together with the general household waste.

Please select option below X. Laptops by Justin Jaffe Nov 27, User shall agree that there will be no comment s submitted to the http: Heatsink assembly Prepare the computer for disassembly Preparation for Disassembly.

HP in-1 Media Reader with This computer contains an internal lithium rx2810 dioxide battery.

  GA-M61PME-S2 SOUND DRIVER DOWNLOAD

Do not jam cables on top of expansion cards or memory modules. The technology and device width can vary between the channels. Port Cover To install the port cover, slide the bottom half of the cover onto the chassis 1then slide the top half of the cover onto the chassis at an angle 2 then rotate the top half down onto the bottom half 3.

HP Compaq dx2810 Microtower PC Special Edition

See your browser’s documentation for specific instructions. If you are adding a drive to an empty drive bay for the first time, you must remove the knockout plate from the bay. How does HP install software and gather data?

Turn off the computer before disconnecting any cables. That’s among the best deals of the year. Nothing herein should be construed as constituting an additional warranty.

Refer to Installing Fx2810 Drives for an illustration of the retainer screws location. Squeeze on the top of the retaining latch attached to the cable end of the connector 1.