Nationally, the average water heater repair cost ranges between $120 and $200, although prices can range up to $400 or more. Water heater repair costs will depend on the type of water heater you have (tankless, electric, natural gas, etc.), the source of the problem, the cost for new parts, and labor rates in your area. Common water heater issues include problems with the thermocouple, thermostat, heating element and leaks. Most standard electric water heaters have two thermostats and two elements. One example for the cost to replace a bad thermostat is $185 for parts and labor. Replacing both the thermostat and the heating element could cost approximately $150-$200. The thermocouple is a safety device that senses when the pilot light is burning and signals the gas valve to close if the pilot light goes out. If your thermocouple is bad or corroded, the average cost to clean and repair it could be between $350 and $400. If your water heater has started to leak, it is usually more cost-effective to invest in a new water heater than to repair it, unless you’re covered by a warranty.
My plumbing experience was to have the plumbing disconnected under the sink so the counter top and new sink could be installed. I thought the service of $115 was high, but usually if there is an additional fees, it is usually rolled into the cost of repairs or labor. This company also charged 3.75 % for putting it on a credit card, which was not mentioned until I received the invoice in the mail after paying on the phone.
Our plumbers are licensed, bonded, and insured and meet our rigid trust certification standards. Our services are guaranteed in writing against defects in materials and workmanship. So if you need to repair, maintain, or improve your plumbing or septic system, you can rely on Parker & Sons. Our plumbing service includes a 100% money back guarantee and our customer care policies are unmatched in the industry.
I thought that my sump pump had ended its life and needed to be replaced. The contractor I found through Home Adviser came out the following day and arrived reasonably promptly. The technician tested the pump and it wasn't responding. He then checked the breaker panel and all seemed well. However he checked to see if power was reaching the outlet, it wasn't so he tripped some breakers and reset them and the power to my pump came on and the pump works so a replacement wasn't necessary. He charged $75.00 which I think was reasonable for a call-out fee and time spent.
Hi. I hope someone can help me. I have a has water heater amd it seems to only work when it wants to. Regardless of amount of use some days I have got water and some days it runs out of hot water immediately even if it hasn't been used all day. And some days it runs out half way through a shower. I have already turned the temperature almost all the way up and nothing is helping. Is there a way too fix this or is it time for a replacement?
During a sewer video inspection, the homeowner can watch over the technician's shoulder as the camera snakes its way through your sewer. After the camera finds the obstruction, it is stopped. The video technician then goes outside with a sewer sonde device which locates the video camera underground. This area is marked with spray paint. If the sewer line later needs to be dug up and replaced, workers will know exactly where to dig. Roto-Rooter provides the video to the homeowner, either on DVD format or online.
Despite the Romans' common use of lead pipes, their aqueducts rarely poisoned people. Unlike other parts of the world where lead pipes cause poisoning, the Roman water had so much calcium in it that a layer of plaque prevented the water contacting the lead itself. What often causes confusion is the large amount of evidence of widespread lead poisoning, particularly amongst those who would have had easy access to piped water. This was an unfortunate result of lead being used in cookware and as an additive to processed food and drink, for example as a preservative in wine. Roman lead pipe inscriptions provided information on the owner to prevent water theft.
Master plumber: To become a master plumber, a person must have a certain number of years' experience as a journeyman plumber, in addition to an associate's degree or training at a vocational school. A master plumber must pass an exam that typically encompasses both written and practical knowledge. They must also complete continuing education hours every year. Oftentimes the business owner, a master plumber is subject to inspection and must make sure all journeyman plumbers working for his or her company are in compliance with plumbing regulations.
It shouldn’t have to be a challenge to find a reliable plumber in your area. We know that you may be wary of less than ideal service. But at Tom Drexler Plumbing, Air & Electric we work with a customer-first mindset. This means your problem becomes our top priority. We go above and beyond to make sure your problem is fully resolved and that you are 100% satisfied with the result. If you are not completely satisfied, we will correct the situation and do not consider the job done until you are confident in the work.